[Fran]

Fran on November 6, 2017 at 10:45 am #5303

Hello, I am from Spain and I have already completed 20 sessions with 22 milliamps and I still sweat a lot 🙁
My device is called Ionomat.
What should I do? Yesterday I put baking soda and I reduced the quantity of tap water (500 ml for each hand).

      

Reply

[[email protected]]

[email protected] on November 6, 2017 at 10:51 am #5311

Hi Fran,

Sorry to hear that iontophoresis is not working for you.

20 sessions with 22 milliamps are quite a lot – over what period did you do those 20 sessions? You need to do a session on daily basis till sweat goes away and then reduce the frequency to maintain that.

I have not heard of Ionomat, so cannot comment specifically on that machine. However, unless there is a problem with your specific piece of machine, I do not think that the machine itself is a issue here.

You are doing the right thing – check the water quality. If you get hard water, adding baking soda may help.

However, in the end, iontophoresis is just one of the options – it works for most people I know of, but may not work for all. You may, unfortunately, fall into that category 🙁

      

Reply

[Fran]

Fran on November 10, 2017 at 4:21 am #5317

I have done those sessions daily.
My water is soft. I think that the water might be the problem, because I have been reading the forum and in many cases the issue is the type of water.

      

Reply

[Fran]

Fran on November 10, 2017 at 4:21 am #5316

I have done those sessions daily. My water is soft. I think that the water might be the problem, because I have been reading the forum and in many cases the issue is the type of water.

      

Reply